Quantcast

My Aching Body

If you sat at your computer in a poor ergonomic position for six hours straight, bending and straightening your elbows 300,000 times or more, you'd expect a repetitive strain injury, right?

Cycling is similar in that it too is a poor ergonomic position with repetitive motions. In a six-hour ride your knees, hips and ankles will bend and straighten approximately 300,000 times. Your neck and back will be in a constant forward position. So if you want to prevent aches in these areas learn the "5 F's of injury prevention"

1) Bike Fit: Andy Pruitt once said changing the seat height by a mere inch changes the mechanics and muscle actions of every joint in the lower extremity.

For example, if you decrease the seat height you increase the forces on the front of the knee, but if your saddle is too high, forces increase in your hamstrings, low back and hands.

What to do: Educate yourself on bike fits and make the appropriate changes. You can also get a professional bike fit.

2) Flexibility / Fatigue ability: Muscular Balance - Think Ying and Yang of muscles and joints. Muscles need to be both strong and flexible to allow proper movement and support of the joints in your body. As mentioned above, this is especially important for cyclists because our joints are either stuck in a static position as with the upper extremity or in repetitive motion as in the lower extremity. If joints are not flexible AND strong then you're asking for trouble. What's more, muscles on either side of the joint need to be balanced. For example, many cyclists have very strong quadriceps muscles (front of the thigh) and relatively weaker hamstring muscles (back of the thigh). This is similar to the unequal guide wires on a tent causing the tent to tip.

What to do:
· Static positions need to be reversed. This means occasionally backward bending when you get off your bike.
· Strengthening and stretching both sides of the body joints. Incorporate pulling and pushing exercises to strengthen the upper body, and hamstring and quadriceps exercises for the lower body. --Use proper pedal mechanics (discussed below).

3) Foundation thru properly progressed training
You might expect an injury if, in one week, you increased weights in the gym by 60%. However, many people think nothing of increasing their longest ride from a 40 mile ride to a 65 mile in one week, the same 60 percent increase. Our bodies can tolerate gradual increases of no greater than 5-10 percent per week of mileage or time increases. Frequent high-intensity rides for strength training sessions will also lead to injury.

What to do:
· Intense rides (greater than 75 percent of max heart rate) should be limited to one to 2-3 days a week. - Gradually progress time spent on the bike and/or mileage in 5 to 10 percent increments per week.

4) Cycling Form Counts
Pushing hard gears is analogous to walking up a flight of stairs two or three steps at a time, when you only need to take them one at a time. By selecting easier gears you break up the same amount of work over more pedal strokes, taking a great deal of stress off of your knees.

Improper pedal form will also cause pain.

What to do:
· You should aim for a cadence (pedal revolutions per minute) of 85 to 95 on a flat road and no less than 70 on a hill. You can achieve this by selecting the proper gear for your ability. However, on a significant hill, this can present a challenge without a triple chain ring on your front gears.
· Use all your muscles to propel yourself forward. With proper pedal strokes, both your quadriceps and hamstrings play a part, Image your pedal going through a full circle; as your foot moves to the bottom position of the stroke, imagine scraping bubble gum off the bottom of your shoe. Then, pull your knees toward your handlebars as you bring your foot to the top of the stroke. This will take pressure off of the front of your knee and give those tired quadriceps arrest.

Not quite fitting the "F's" but just as important:

5) Nutrition
Proper food and electrolytes will fuel those muscular engines. Imagine trying to run an unleaded car on leaded gas. This is what happens when we do not fill a body with what it needs to carry out those long or intense rides.

What to do:
· For cyclists and other endurance athletes 55 to 65 percent of our fuels should be in the form of carbohydrates, mostly complex. Fifteen to thirty percent of our foods should be fats and 10 to 20 percent protein.
· Your fluid or your food or drink should contain sodium and potassium. (approximately 1000 milligrams / hour). These nutrients allow those nerves and muscles to work properly. Sport dinks, pretzels, bananas are good sources.
· You burn 200-400 calories for every hour of riding. So if you don't want to bonk, run out of fuel, you better replace it!

6) Hydration
Fluid loss as little as 2% (3 lbs for a 150lb person) can lead to a decrease in performance. Six percent can send you to the hospital with an IV in your arm.
· Weigh yourself undressed before and after exercise. It should be the same! It is easy to drop 2-4# of water on a hot or hard ride. This enough to make you slower, and another day like it could put you in the ER! For every 1 lb lost you should drink - a liter. That is about - a large water bottle
· Watch your urine: It should be almost clear and without smell. If it is changing then you are dehydrating.
· Depending on the temperature, your exertion, and your body: You should drink - a large water bottle every 30-45 minutes. Said another way that's 3-4 glasses for every hour that you workout

Resources List

1) Curtis Cramblett, PT, CSCS, Expert Level cycling coach, CAR 6,7 (510) 325-1884, Curtis@RevoutionsInFitness.com - 15% Discount on all services to ALC riders including Bike fitting, Personal training, Cycling / Fitness Coaching
2) My / ALC Web site articles www.RevolutionsInFitness.com
3) Books
Long Distance Cycling, Burke
Serious Cycling, Burke
Cycling Past 50, Friel
Indoor Cycling - Heart Rate Training, Sally Edwards
Precision Heart rate training, Ed Burke
Smart Cycling, Arnie Baker
Road bike training, Fred Matheney

For in depth articles on the subjects mentioned in this article, please visit my website at RevolutionsinFitness.com

Curtis@RevolutionsInFitness.com
www.RevolutionsInFitness.com
w:(510)325-1884
Licensed Physical Therapist
Personal Trainer
Certified Strength and Conditioning Specialist
USCF, USA Expert Level Cycling Coach
Certified Spinning Instructor

Curtis Cramblett PT CSCS RevolutionsInFitness
Curtis Cramblett, PT, CSCS, USCF expert level cycling coach. Curtis owns Revolutions in Fitness, a personal training and coaching business reaching a wide population including the recreational athlete, elite cyclist and general public. Certifications: NSCA CSCS, PT, IDEA Master PFT